News classification
Excellent performance of jigsaw glue
Time:2019-04-10 12:56:23 Page view (785)
Excellent performance of jigsaw glue
Performance characteristics of jigsaw glue
[Appearance] white viscous liquid
[pH] 5-7
[Solid content] 50±2%
[Viscosity] ≥ 160000 CPS
Features: environmentally friendly, non-toxic, high viscosity, fast setting; high content, fast drying, weather resistance
1. The ratio of the glue and the curing agent is 100:10-15, and the ratio of the curing agent is less than 10%, which has no obvious effect, and above 15%, it will cause chipping.
2. When the rubber and the curing agent are mixed, the chemical reaction will occur, and there will be different degrees of foaming. This is a normal phenomenon and does not affect the bonding effect. The prepared glue should be used up within 2 hours, but 1 It’s better to run out in hours.
3. After the glue is applied, the whole board must be assembled and pressurized within two minutes. If the destructive test is required, please do it 24 to 48 hours after the board is finished, otherwise it is inaccurate data.
Performance characteristics:
The product has the advantages of fast drying speed, high bonding strength, excellent water resistance, acid and alkali resistance, good flame retardancy, aging resistance and convenient construction. At 80 ° C above zero, there is no temperature difference reaction at minus 49 ° C, no softening, cracking and opening.
Scope of application
This product is mainly used for the non-splicing of various hardwoods such as eucalyptus, birch, oak, teak, and ironwood.
Shanghai Zhenniu Chemical Co., Ltd.
Performance characteristics of jigsaw glue
[Appearance] white viscous liquid
[pH] 5-7
[Solid content] 50±2%
[Viscosity] ≥ 160000 CPS
Features: environmentally friendly, non-toxic, high viscosity, fast setting; high content, fast drying, weather resistance
1. The ratio of the glue and the curing agent is 100:10-15, and the ratio of the curing agent is less than 10%, which has no obvious effect, and above 15%, it will cause chipping.
2. When the rubber and the curing agent are mixed, the chemical reaction will occur, and there will be different degrees of foaming. This is a normal phenomenon and does not affect the bonding effect. The prepared glue should be used up within 2 hours, but 1 It’s better to run out in hours.
3. After the glue is applied, the whole board must be assembled and pressurized within two minutes. If the destructive test is required, please do it 24 to 48 hours after the board is finished, otherwise it is inaccurate data.
Performance characteristics:
The product has the advantages of fast drying speed, high bonding strength, excellent water resistance, acid and alkali resistance, good flame retardancy, aging resistance and convenient construction. At 80 ° C above zero, there is no temperature difference reaction at minus 49 ° C, no softening, cracking and opening.
Scope of application
This product is mainly used for the non-splicing of various hardwoods such as eucalyptus, birch, oak, teak, and ironwood.
Shanghai Zhenniu Chemical Co., Ltd.
Down: (0)